Product ID:KODAK SUPRALIFE ALKALINE BATTERY SIZE: KD (1.5V) IEC-LR20
MSDS Date:03/03/1992
FSC:6135
NIIN:00-900-2139
Status Code:A
MSDS Number: CKZSH

EASTMAN KODAK COMPANY

343 STATE STREET
ROCHESTER, NY 14650
US

Emergency Phone: 7167225151

Info Phone: 716-722-5151

Cage: 19139

EASTMAN KODAK CO GOVERNMENT MARKETS CONTRACTS

ROCHESTER, NY 14650-1115 US

Telephone: 716-722-5151/(800) 242-2424

Cage: 19139

37% -

RTECS: PS1006506

Fraction By Weight: 5%

MERCURY

CAS: 7439-97-6

RTECS: OV4550000

Fraction By Weight: .001%

OSHA PEL SEE TABLE Z-2

ACGIH TLV: 0.025 MG/M3

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

Medical Cond Aggravated by Exposure:

First Aid:SKIN: IMMEDIATELY FLUSH WITH PLENTY OF WATER FOR AT LEAST 15
MINUTES. IF SYMPTOMS
ARE PRESENT AFTER FLUSHING, GET MEDICAL ATTENTION. EYES: IMMEDIATELY
FLUSH WITH
PLENTY OF WATER FOR AT LEAST 15 MIN UTES AND GET MEDICAL ATTENTION.
BATTERY
INGESTION: OBTAIN IMMEDIATE MEDICAL ATTENTION.

Extinguishing Media:USE AN EXTINGUISHING MEDIUM APPROPRIATE FOR THE
SURROUNDING FIRE.
Fire Fighting Procedures:USE A POSITIVE PRESSURE SELF-CONTAINED
BREATHING APPARATUS IF BATTERIES ARE INVOLVED IN A FIRE. FULL
PROTIVE CLOTHING IS NECESSARY.
Unusual Fire/Explosion Hazard:BATTERIES MAY RELEASE TOXIC MERCURY
VAPORS AND/OR IRRITATING POTASSIUM HYDROXIDE FUMES IF EXPOSED TO
FIRE OR HIGH TEMPERATURES. BATTERIES MAY VENT IF EXPOSED TO
EXCESSIVE HEAT OR FIRE.

Handling and Storage Precautions:DO NOT STORE BATTERIES IN A MANNER
THAT ALLOWS TERMNLS TO SHORT CIRCUIT. STORE
BATTERIES IN A COOL (BELOW 70F), DRY AREA THAT IS SUBJCT TO LITTLE TEMP
CHANGE. DO NOT
PLACE NEAR HEATING EQPMENT, NOR EXPSE TO DIRCT SUNLIGHT FOR LONG
PERIODS. ELEVATED
TEMPS CAN RESULT IN REDCED BATTERY SERVCE LIFE.

Supplemental Safety and Health
**LITHIUM-X: ( CLASS D EXTINGUISHING MEDIA) IS EFFECTIVE ON FIRES
INVOLVING ONLY A FEW POWER CELLS.

HCC:N1
Solubility in Water:INSOLUBLE
Appearance and Odor:9V BATTERY

Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:STATIC,SPARKS,FIRE.DO NOT CHARGE.DO NOT
REVERSE POLARITY.AVOID PHYSICAL DAMAGE.
Hazardous Decomposition Products:BATTERIES NORMALLY EVOLVE HYDROGEN GAS
WHICH IS EXPLOSIVE OR FLAMMABLE WITH AIR.

Waste Disposal Methods:CONSULT LOCAL, STATE AND FEDERAL ENVIRONMENTAL
PROTECTION AUTHORITIES FOR THE
MOST CURRENT REGULATIONS REGARDING DISPOSAL OF BATTERIES. DO NOT
INCINERATE OR
EXPOSE BATTERIES TO FIRE.

Toxicological Information:ALKALINE BATTERIES ARE NOT DESIGNED TO BE
RECHARGED. CHARGING AN ALKALINE BATTERY MAY RESULT IN ELECTROLYTE
LEAKAGE AND/OR VENTING. NEVER DISASSEMBLE A BATTERY. SHOULD A
BATTERY UNINTENTIONALLY BE CRUSHED THUS RELEASING ITS CONTENTS,
RUBBER GLOVES MUST BE USED TO HANDLE ALL BATTERY COMPONENTS. IN
THE EVENT OF SKIN OR EYE EXPOSURE TO THE ELECTROLYT REFER TO FIRST
AID INFORMATION.*

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

Ecological:*MORE THAN A MOMENTARY SHORT CIRCUIT WILL GENERALLY REDUCE
THE BATTERY SERVICE LIFE. EXTENDED SHORT CIRCUITING CREATES HIGH
TEMPERATURES IN THE CELL. HIGH TEMPERATURES CAN CAUSE SKIN BURNS
AND CAUSE THE CELL TO VENT.**

Transport Information:**THE USE OF OLD AND NEW BATTERIES OR BATTERIES
OF VARYING SIZES AND TYPES IN THE SAME BATTERY ASSEMBLY SHOULD BE
AVOIDED. THE BATTERIES ELECTRICAL CHARACTERIESTICS AND
CAPABILITIES VARY AND DAMAGE M AY RESULT TO THE BATTERIES OR
ELECTRICAL EQUIPMENT.***

SARA Title III Information:THE USE OF OLD AND NEW BATTERIES OR
BATTERIES OF VARYING SIZES AND TYPES IN THE SAME BATTERY ASSEMBLY
SHOULD BE AVOIDED. THE BATTERIES ELECTRICAL CHARACTERISTICS AND
CAPABILITIES VARY AND DAMAGE MAY RESULT TO THE BATTERIES OR
ELECTRICAL EQUIPMENT. USE NICKEL PLATED STEEL (OR STAINLESS STEEL)
FOR POWER TERMINAL CONTACTS. DO NOT DIRECTLY SOLDER TO THE
BATTERY. MAY CAUSE VENTING AND/OR EXPLOSION. AVOID ENCASING
BATTERIES IN AIRTIGHT COMPARTMENTS. FLAMMABLE HYDROGEN GAS,
NORMALLY GENERATED, CAN FORM EXPLOSIVE MIXTURES. PROVISIONS FOR
VENTING MUST BE PROVIDED. NEVER COMPLETELY ENCAPSULATE A BATTERY.
TO DO SO WILL INHIBIT THE SA
State Regulatory Information: